LeNET! - The best way to finish off any renewables installation is to show it off to its full potential and what better way than by using a state-of-the-art web-integrated LeNET system that can be accessed from anywhere or by onyone you want...

For Business.. 
When you decide to install a renewables solution, the best thing you can do is shout about it as there is a lot of good PR out there for green companies.

Traditionally a display system for renweables consisted of a small wooden box with either an LCD screen or LED's. This was fine for the 70's but this day and age with digital technology and the internet where it is - you want to do that bit more to showcase what you have done.

The systems are all cost-effective and can be fully customised. They can show as much or as little as you want. Typically, each installation wants to show...

• Total power generated on site
• Total imported electricity
• Exported electricity
• Carbon savings and
• Weather station inputs (wind speed, wind direction, temperature etc)

However you can also monitor water, gas, heat or even down to individual business units or circuits.

We give you remote access to the system so no matter where you are, you can log in to see whats happening. This also means that you can show it on as many computers / TV screens as you want VERY cost effectively.

For Schools.. 
As well as all of the above, the display system is an education tool and a nice glossy front-end for people coming into the school when it is displayed in the reception area.

Outputs to csv files means that you can have the data in as much or little detail as you need and will allow you to create plenty of tables, charts and usage statistics and can allow cross-comparisons between technologies installed and even comparisons between other school sites in the area.

Again, since the display is online the output can be shown on any number of computers and TV's throughout the school and even at home!

Security.. 
The Linux based system sits completely seperate from the corporate / council IT network on an off-site hosting server. This, combined encrypted transmissions and password access to sensors and sensor data, means that the system as a whole is very secure. There is NO need for any changes on the network security protocol.

Flexibility.. 
The fully integrated web display is a modern and flexible design that can be changed any number of times and can have any number of inputs. These inputs can be (but not limited to)...

• Wind power
• Solar hot water
• Solar electric
• GSHP
• Biomass/CHP
• Hydro
• Imported electricity
• Exported electricity
• Weather station inputs (wind speed, direction, rainfall, temperature, solar irradiance)
• Historical data
• Forecasted data
• Gas consumption
• Water consumption
• + more!

Installation... 
Simple and straightforward with minimum requirements! All we need are power and data (RJ45) sockets next to each telemetry device (modem) and clear access to the internet - so all we need is an IP address prior to arriving on site so all units can be pre-programmed. On top of this just let us know how many TV's you want to display the output on so we can provide the embedded PC's.

We will supply all the equipment and install it however our preference is that the 5-core shielded cables (between sensors and telemetry devices) be ran in advance by someone who is familiar with the cable trays and routes on site.

The Alternative... 
For not too far off the same money...